BP-D Series Pulley (Rotating Shaft)

1200 Series Conveyor Roller

BP-R Series Pulley (Fixed Shaft)

BP-D Series Pulley (Rotating Shaft)

  1. Thermal treated shaft
  2. Special welding equipment and technology
  3. New structure, strong and reliable

Description:

①  Driven Pulley：
Main driving component for centre drive belt conveyors:
Select BP-D series pulley (rotating shaft).

②  Head & Tail Pulley：
Installed at each end of a belt conveyor according to the different drive type and structure:
a、Centre drive:
Change the belt direction: Select BP-R series pulley (fixed shaft) or DP-D series pulley (rotating shaft)
b、Head or Tail drive:
Drive Pulley: Select BP-D series pulley (rotating shaft)
Idler Pulley: Select BP-R series pulley (fixed shaft) or BP-D series pulley (rotating shaft).

③  Snub Pulley：
Used to increase the belt wrap angle for the driven pulley, tension and tracking the belt.
Select BP-R series pulley (fixed shaft) or 1200 series conveyor roller.
Be careful about the belt tensionning and siding focce when using as redirection & tensioning.

④  Carrying Roller：
Used to support the belt, simplify structure and reduce friction:
Select 1200 series conveyor roller.

Dimensions(Surface Z/P)：

Straight tube is available-not tapered ; “( t )”is not accurate data.
If there is dynamic balance requirement for products, please contact us.

Precaution of broken shaft: when installed by shaft through the motor, the torque that the shaft takes is quite big, please pay attention to the actual torque output and installation detail, otherwise, the shaft will break. Please contact us for details.

Prcaution of abrasion of the shaft: 

  1. Please install the bearier with frame, and make sure the screw is fastened.
  2. Machine flat surfaces on both sides of the shaft, so as that the screws can reach the surfaces and thus be fastened.

Dimensions(Surface Coating Type)：

Straight tube is available-not tapered ; “( t )”is not accurate data.
Coating material ：Polyurethane (yellow)
(If the pulley length is out of above, please contact us.)

Precaution of broken shaft: when installed by shaft through the motor, the torque that the shaft takes is quite big, please pay attention to the actual torque output and installation detail, otherwise, the shaft will break. Please contact us for details.

Prcaution of abrasion of the shaft: 

  1. Please install the bearier with frame, and make sure the screw is fastened.
  2. Machine flat surfaces on both sides of the shaft, so as that the screws can reach the surfaces and thus be fastened.